OK fairly new to this machine, its all up and running been doing some prints with it.

A few questions that I am sure are simple to answer for those that know.

If you were to do a full width print, what margin would have on the left hand side when looking from the output side. We get about a 10+cm margin.

When looking in the rip software (Flexisign 8) you have to put at least a 10cm margin on the other side (right) or it will try to print over the edge of the page.

Is there somewhere where this is adjustable? I have not found an adjustment yet.

It seems as if the image postion shown in the software is over more to the left on the printer than it is in real  life.