Usually this can happen when you reprogram a servo and set direct to CW instead of CCW

Vutek Field technical Procedure  :

Changing the Media Belt Direction This document describes the procedure for changing the media belt direction on the PressVu 200.

Procedural Steps Note  Note 

 

1. th cable from the right on the bulkhead connector. Follow the cable down to where it plugs into the printer CPU. The cable should be labeled with a tag that reads AA90928.

    

    

   Disconnect the cable from the communications port on the printer CPU and connect it to COM 1 on the Workstation CPU. COM 1 is located between the monitor connection port (VGA) and the keyboard connection port.

Note 

 

Note 

 

: The printer will error and the beeper will sound. This is normal and is cleared later in the procedure. : Some motherboard models vary slightly but the COM 1 port should always be near the keyboard and monitor connections. Figure Figure 2: View of ports looking down at the top of the electronics box From the Windows desktop, close UltraVu if it is running. In the Start menu click Programs > Emerson Control Techniques > Power Tools-FM > Power Tools-FM. From the Power Tools-FM software select the Options menu > Preferences > Communications. Click the Configure Serial Port button. Verify that COM1 is selected with 19200 baud rate. Select OK to close the Communications Setup dialog box.  Select OK again to close the Modbus Setup dialog box. Select the Device menu and choose Upload All. In the window, choose Selected Drives and enter 2. Click OK; the media drive servo controller is now connected. On the open window, select the Setup tab and verify that the Target Drive Address  

is 2. Below the

1. Target Drive Address, set the Positive Direction to CCW Motor Rotation 

. Click the

Update button at the bottom of the window. Close the Power Tools FM software. It is not necessary to save the changes when

prompted.

Move the serial communications cable back to its original location on the CPU.

Clear the error on the Firmware computer.

Reboot the computer and test the belt.